Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

serial communication through uart

Status
Not open for further replies.
S

shankar458

Newbie level 4
Joined
May 10, 2011
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,309
how to give a text file through hyperterminal to viertex ml403


i need code and ucf also

pls any one can help me for thid
 

in hyperterminal there is an option to called transfer. in that there is a option to send text file...

select the text file and send it.... on the other end you need to store the incoming data in a suitable array of a good size.... for pc and board you need a max 232 IC connected to controller... and a serial cable....
 

thank you............

actually we have loaded one program on to fpga
for that i have to send input text file through hyper terminal
but for communicating between uart port and fpga we have to write any code


data is sending serial wise .program has to take 8 bits at a time and do some operation on that .then it will give 8 bit output that will take by hyper terminal.
here we are sending pixels of a image in the form of text file.
 

in this post there is no code,no testbench etc...........
pls can u check once
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top