Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Global buffer decleration

Status
Not open for further replies.
I

itmr

Member level 3
Joined
Nov 5, 2010
Messages
55
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,750
HI ALL
I AM NEW ALTERA user and i need help to configure signal as global buffer.
i mean ' i generate a clock from the source board clock and i need to pass it to several componenets- so i need to use global buffer.
how can i decleared this clock as global buffer in altera design suite?
 

The Altera synthesis tool is assigning gloabl clock networks automatically based on fan-out and timing requirements. Normally you don't have to do anything. I suggest to implement the design and review assignment of global clock networks in the compilation report.
 
  • Like
Reactions: itmr

    I

    itmr

    Points: 2
    Helpful Answer Positive Rating
yes u guess you right but i geting an error shen i try to connect the genereted clock to several units by temporary signal...
mybe this is my problem? how should i connect the generaetd clock to other units?
 

Please report the error. I presume, that you know about the difference between error an warning. An eror in behavioral code is most likely a HDL syntax error. If you are however connecting vendor specific IP to a generated clock, you may be doing something not supported by a specfic device family.
 
  • Like
Reactions: itmr

    I

    itmr

    Points: 2
    Helpful Answer Positive Rating
sorry it was my mistake - i declered one of the port as output - i mean i connect output to output

now it works well

thank u all and sorry for distrubing u guy"S
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top