Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to see rule check in Altium?

Status
Not open for further replies.
H

hithesh123

Full Member level 6
Joined
Nov 21, 2009
Messages
324
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Location
lax
Activity points
3,548
I am new to altium. I just designed by 2nd schematic and there were some single pin nets.
How do I get them to show up?
 

Re: Rule check in Altium

Doble-click net object and set properties to turn it visible.

+++
 

Re: Rule check in Altium

I double clicked all I got was the wired properties - like color and width.
 

Re: Rule check in Altium

Sorry the mistake...it just cunfused to CAD I´m using now ( Mentor Graphic )
Well, I opened a project here in "Altium Designer 6" and didn´t see any option to hide it.

Maybe your schematic don´t have net yet to those wires.

+++
 

Re: Rule check in Altium

While you are in the schematics, run "project", "compile". after that have a look at the "messages" window. It will report warnings and errors.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top