Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Below attached my design for high side current sense with gain of 33. When i vary my current from 80mA to 250mA. The output of the current sense still remain 1.55V. Why there is no changes for the output of current sense?
If the connection is correct, theoretically with vary current the current sense output will be vary too. For my case the current sense output doesn't change at all. At first i thought my IC burned,so i replaced with new one , sadly result is still the same
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
