Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Atmel XMega Programming problem

Status
Not open for further replies.
P

prafiee

Newbie level 5
Joined
Feb 10, 2010
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,331
I need to know with which programmers can Xmega be programmed?
Can Stk200/300 be used? as well, Can I use Codevision for Xmega programming?
I couldn't find Xmega devices in the list of programming device, however Xmega are present in devices list when we make project.
 

stk200 and stk300 are older versions. Try stk600.

Only the latest version of codevision 2.05 supports xmega
 

I have worked with codevision 2.05. It supports Xmega but there is no xmega device in programming device list in Tools>>chip_programmer>>chip. With this condition can I program Xmega using Codevision
I am going to use AVRISP mkII programmer. Is it ok? It seems that Xmega cannot be programmed through ISP and I have to program through PDI. Is it true?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top