Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am sure you can although I am not familiar with Orcad as I use Eagle. Using Eagle you define a polygon and draw it around the perimeter of the PCB design, using solid or hatch and defining the width. You can then name it Vss or GND so that it picks up all the relevant nets from the design.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.