Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

copper pour/copper area to single layer board.

Status
Not open for further replies.

m_kavith

Member level 3
Joined
Jun 14, 2010
Messages
58
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
chennai
Activity points
1,638
im orcad 9.1, is it possible to add copperpour/area to single layer board.
 

im orcad 9.1, is it possible to add copperpour/area to single layer board.

I am sure you can although I am not familiar with Orcad as I use Eagle. Using Eagle you define a polygon and draw it around the perimeter of the PCB design, using solid or hatch and defining the width. You can then name it Vss or GND so that it picks up all the relevant nets from the design.
 

yes you can... use obslacle tool to do the job
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top