+ Post New Thread
Results 1 to 4 of 4
  1. #1
    Member level 3
    Points: 838, Level: 6

    Join Date
    Jun 2010
    Location
    chennai
    Posts
    58
    Helped
    0 / 0
    Points
    838
    Level
    6

    copper pour/copper area to single layer board.

    im orcad 9.1, is it possible to add copperpour/area to single layer board.

    •   AltAdvertisement

        
       

  2. #2
    Junior Member level 1
    Points: 1,201, Level: 7

    Join Date
    Aug 2009
    Location
    Durban
    Posts
    17
    Helped
    5 / 5
    Points
    1,201
    Level
    7

    Re: copper pour/copper area to single layer board.

    Quote Originally Posted by m_kavith View Post
    im orcad 9.1, is it possible to add copperpour/area to single layer board.
    I am sure you can although I am not familiar with Orcad as I use Eagle. Using Eagle you define a polygon and draw it around the perimeter of the PCB design, using solid or hatch and defining the width. You can then name it Vss or GND so that it picks up all the relevant nets from the design.



    •   AltAdvertisement

        
       

  3. #3
    Full Member level 4
    Points: 3,155, Level: 13
    Achievements:
    7 years registered

    Join Date
    Jun 2010
    Location
    INDIA
    Posts
    199
    Helped
    78 / 78
    Points
    3,155
    Level
    13

    Re: copper pour/copper area to single layer board.

    yes you can... use obslacle tool to do the job



    •   AltAdvertisement

        
       

  4. #4
    Member level 4
    Points: 1,324, Level: 8

    Join Date
    Nov 2010
    Location
    Muscat, Oman
    Posts
    73
    Helped
    14 / 14
    Points
    1,324
    Level
    8

    Re: copper pour/copper area to single layer board.

    Obviously yes!

    Obstacle
    Obstacle Type
    Width - Spacing b/w traces

    Done!



--[[ ]]--