Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Repair Info HP-5342A Frequency Counter

Status
Not open for further replies.
F

fdc681

Newbie level 3
Joined
Jan 27, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,294
Does anyone know how to replace the fuse (HP-5342A) for the 10Hz-500Mhz input? I unscrewed the BNC connector but the fuse want pull out. Is one end soldered to the circuit board?

Thanks, Fred
 

fdc681 said:
Does anyone know how to replace the fuse (HP-5342A) for the 10Hz-500Mhz input? I unscrewed the BNC connector but the fuse want pull out. Is one end soldered to the circuit board?

Thanks, Fred
Click to expand...

The fuse is not soldered , it is strongly in its cabinet . Maybe the fuse go out , if you put the whole item to the top , then shake it . Or put a small nail into the fuse cabinet . If this fail , you must remove the complete fuse cabinet . Refer to the service manual . It is at the Agilent homepage . Good Luck .
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top