Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to make padmaster in PADS layout ? (that is pads holes or drill holes open)

Status
Not open for further replies.
S

scriptx007

Member level 1
Joined
Jun 1, 2010
Messages
37
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
india
Activity points
1,519
Hello every body , i m good designer in orcad and altium . in orcad or altium there is option of "keep drill holes open" . but in PADS layout there is no such option . i want top or bottom side layer with drill holes open . when i make postscirpt file this option is not available. dont tell me to do tht from gerber file. can anybody tell me how to achive that in PADS layout . sample is attached just chk it out
 

Attachments

  • Top Layer.pdf
    8.8 KB · Views: 98

Hi, ia m also phasing the same problem. Please help me out if you have found the solution.
I could get it for throughhole components and few vias also but vias which are under copperpour are not opening.
Thans,
Vamsi

 
Last edited:

hi vamsi115,

i didn't found solution in PADS. but in cam350 we can do it. by changing drill hole colors. or else in GCprevue it is easy. wen u import drill file in gcprevue. it directly gives u padmaster.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top