Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to drive the IGBTS in 3000w power inverter?

Status
Not open for further replies.
K

kips

Newbie level 2
Joined
Feb 3, 2011
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,294
hi everyone. I am designing a half bridge inverter that uses igbts. i need help on how to drive the igbts so as to obtain a sine wave at its output. the input voltage is 400vdc.
 

Re: 3000w power inverter

How far has you became in your design?
 

thanks for the assistance. i have the pulse width modulation circuit, but coupling it to the gate driver has been quite a challange. the problem with where i am is finding the right materials to guide you thru the entire design process. I also can't find meaningfull resourses on how to make the entire design.
 

Hi. The easiest way to make an interface between logic circuits and IGBT is to use an "Gate driver IC", like IR2103 or similar.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top