Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Block ram and .coe file

Status
Not open for further replies.

hodahussein

Full Member level 2
Joined
Apr 17, 2007
Messages
144
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
2,276
dear all

i need to know if i have .coe file and this file contain 1000000 word and each word represent by 2 bit and load this file in block ram of virtex2pro is this practically or not

wait your reply
regards
 

You can check it your self.

Go to Coregen, configure BockRAM and see if you can get enough bits and address lines with your desired configuration.
 

hi

ok i know enough about block ram buut i asked about is this practical or not "load block ram with 2000000 bit" or not ?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top