Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
check the internal pin or surface inside the connector is shorted to which pin.. thats is signal and the external metallic surface shorted to the pin is ground
It is visible from the picture, the outer big metal barrel is the ground and is connected to the front pin,
the pin in the center of the plug is the signal and is connected to the rear side pin.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
