Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Li-I0n battery deep discharge protection

Status
Not open for further replies.
B

bikashh

Full Member level 5
Joined
Nov 28, 2009
Messages
264
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
india
Activity points
3,132
hello friends,
I am trying to construct a circuit to protect my battery which is Li-Ion,3.7V,6A from deep discharge.Please help

Thanks in advance
 

make a pic type low voltage 10bit mcu sence tickle charge etc in loop
in texas instruments they have also 0.9volt operating mcuz
play safe and that will lit red light on led for low battery ,u can make four five bar battery power showing light ledz
and also power some transistor for switches off your equipment
i have make this with two nokia bl5c (torn off circuits) on top in series, then sence both voltages on both batteries positive
using pic 16f876
and battery pack for general use
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top