Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Linking Database library to Sch and footprint Library in Altium

Status
Not open for further replies.

khanna_gunjan

Member level 3
Joined
Jul 18, 2006
Messages
64
Helped
9
Reputation
18
Reaction score
7
Trophy points
1,288
Location
Nürnberg, Germany
Activity points
1,699
Hi,

I have a database library for Altium and now i want to aad a new component group to it. i inserted a new table, then added the required parameters for the new part.

Then i have created a new sch. symbol library and footprint library. I have now the new symbol and footprint for the part inside.

When i want to place this new part through the database library, I see only the parameters enter into the Database tabel, but no symbol or footprint.

Could anyone please suggest where could be the failure in the link
 

Shematic symols & footprints are linked in database file i.e. database.MDB
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top