Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to design "current sense amp " in thr BUCK reg

Status
Not open for further replies.
M

mitgrace

Full Member level 6
Joined
May 8, 2004
Messages
367
Helped
6
Reputation
12
Reaction score
2
Trophy points
1,298
Activity points
2,526
Dear all:

Does any body know how to design ""current sense amp " in thr BUCK regulator , Now I use external Power MOS (PMOS and NMOS) . so that I don't how to detect the current ? and How to do the ramp compensation ?
Does anybody know that ? Any document ? Thanks
 

Re: How to design "current sense amp " in thr BUCK

please reading
bipolar an dmos integrated circuit design
10.9 switch regulator page 532 fig-10.33 show SG1524/3524
use current sense limit for output BJT device ...

another ua78s40 use series 0.3 ohms for current sense
if you use mos you can series resistor ..
as I know someone use Power MOSFET internal Rds ..
becuase power mos "ON" have 20~30m Ohm * 5A = 150mV ..
you can sense current ...
 

Re: How to design "current sense amp " in thr BUCK

Dear andy :
Thanks your comment , Actuall I use external PMOS and NMOS , so that I don't know where we can sense the current , Maybe lx , or Mos , But I don't have sense now , My specific is 3.3 to 1.8 Buck regulator , I am looging the PMOS/NMOS , Do you have any comment ? Thanks
 

Re: How to design "current sense amp " in thr BUCK

as I know , someone use split mos finger .. and use current-mirror for measure current ..

but I think use small resistor is easy way
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top