Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

RF power amplifier design simulation

Status
Not open for further replies.
W

whlinfei

Member level 2
Joined
Dec 31, 2008
Messages
48
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,658
Hi All,

I have just finished a RFPA design using Cadence.
For a typical RFPA design, what simulations do I have to run to get some standard parameters?
Like IP3, spectral regrowth, maximum output power all that?

Thank you.

Best Regards,
whlinfei
 

Hi,
You should perform at least an harmonic balance 1 tone simulation to get Gain, PAE and Pout of your RFPA?

I must say I don't realize how did you do to finish a design without any circuit simulation...
 

Hi,

I have done some simulation using SpctreRF. I wonder if there are some simulation can be run from virtuoso schematic. I hope you can provide some details on the simulations that can be run.
thank you.

Best Regards,
whlinfei
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top