Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Designing amplifiers with BJTs.

Status
Not open for further replies.

ashish_chauhan

Full Member level 5
Joined
Sep 2, 2007
Messages
266
Helped
48
Reputation
96
Reaction score
9
Trophy points
1,298
Activity points
2,674
HI Friends,

what I am going to ask might be funny but here it is:-

where to start for designing BJT based amplifiers... ?

I have ample experience in amplifiers with MOSFETS...

thanks
 

As you might be aware before designing any amplifier it is essential to understand the device physics and its I/V characteristics. To start right away designing amplifiers with BJTs, first understand the DC and small signal analysis. Later you may get into Frequency response and feedback and multistage. Its almost similar to designing with MOSFETs ...Two suggested books are 1. Microelectronics by Sedra and Smith 2. Fundamentals of Microelectronics B. Razavi.. Hope this helps..
 

hey
try to get a hold on an old version of Paul R Gray's fundamentals of analog circuits
its all about BJTs and so helpful
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top