Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
can anyone explain the rewires and Device mismatch errors in LVS.I have attached the screenshot of device mismatch tool.the left half window shows schematic devices and the right side indicate layout devices.how to rectify these.thanks in advance
As far as assura goes the device errors are always accurate since even the swap errors are identified only in device errors. As per the rule sets inside assura a rewire or net generally would look for a equivalent type of device in schematic and layout. Always better to clean rewires 1st then take up devices . Again this depends on individuals comfort level
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
