Kaleborg
Member level 4
Hello,
In my project I'm using LM3S3748 ARM chip. I must be able to capture the falling edge of a signal running at 2.5 - 5MHz and then generate interrupt. My question is what would be better/easier to use and what is the difference between these two methods. As I'm looking at the datasheets both methods seem to be doing the same thing.
Thanks in advance.
Regards
In my project I'm using LM3S3748 ARM chip. I must be able to capture the falling edge of a signal running at 2.5 - 5MHz and then generate interrupt. My question is what would be better/easier to use and what is the difference between these two methods. As I'm looking at the datasheets both methods seem to be doing the same thing.
Thanks in advance.
Regards