Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

pic 16f877a interfaceing

Status
Not open for further replies.

lina889

Member level 1
Joined
Aug 20, 2010
Messages
35
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
JORDAN
Activity points
1,557
i want to know if i can use pic16f877a to interface the following with micro c language
1- three DC motor
2--10 sensor
3-interface with PC
4-led

all that with micro c language
 

short answer - yes.

longer answer - but what you can do with them is
a case for your design.

jack
 

i want to make automatic car parking system
but first i have to chose the PIC and the language
now i will use pic 16f877a
but it is good to use micro basic language because am good in it ????????
 

Why not? If you know the language then whats the problem in coding in C?
Regards,
Jerin. :)

---------- Post added at 04:46 ---------- Previous post was at 04:42 ----------

Just check out this link. This may help you.
**broken link removed**.
Regards,
Jerin.
 

Theoreticaly Yes, you can use, but you must use specific hardware, for example for 10 sensors, if you use SPI, you need only one SPI channel but with 10 chip enable pins (one CS pin to one sensor), to communicate with PC you use one UART port, the LED's is not a problem, so the main problem is DC motors (for example use Opto-Isolated DC Motor Board, this board will help you in your design)...
regards
 

my Dr. told me that he want me to use micro basic
can i use it for all of that interface like before instead of micro c ????
 

I have not used micro basic but used micro c. But i think it can be done. Do refer to the user manual of micro basic.
Regards,
Jerin. :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top