Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

class e and class f rf power amplifier for ISM band

Status
Not open for further replies.

azfarsensei

Newbie level 6
Joined
Jul 28, 2010
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
malaysia
Activity points
1,347
eloo.. i need help.. i design the rf amplifier for class e and classf by using the Agilent MGA-82563 component . but in CST microwave studio dont have the libry of this component..so

how can i replace this component that should be able have another component in CST sofware

or anybody have source where can i get the libry of my component.

and last anybody can help b to get the s-parameter of my component which operate at 2.4GHz and5.8GHz cause in datasheet that not state the value of this range freq
 

You can not change the class of an amplifier.It has own bias and it's been developed for certain class of operating.
 
azfarsensei said:
so..how can i simulate the component in CST microwave design
You can not simulate active devices in CST.
CST is 3D EM simulator, not for active circuits.That's why you couldn't find this amplifier in its library.
 
so big boss..

wish sofware u prefer for me.. and how can i get that sofware
i hope free sofware :)

cause this procjet for my last degree procjet..so many cost
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top