Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

opamp simulation help

Status
Not open for further replies.
windknows

windknows

Junior Member level 2
Joined
Jun 13, 2005
Messages
21
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,283
Location
China
Activity points
1,385
did you try setting Vdc to half the supply instand of zero?

the feedback will force the output to follow the input, so if you set the input to zero, the output will also be closed to zero volt, and since this cascode only have limited output swing, the nmos in the cascode won't work anymore..
 

    S

    simon0123

    Points: 2
    Helpful Answer Positive Rating
if I set the VDC = 1.65V, the nmos will work??
 

i think it should work, or maybe you can set it to the voltage of the net57. if it still not work, then maybe you should check the bias for these transistors
 

after I set the VDC = 1.65 I see the gain is about 83dB. The following is the result, is it correct?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top