Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Calibre Interactive could not be licensed sufficiently

Status
Not open for further replies.
N

nana_7488

Member level 1
Joined
Feb 2, 2010
Messages
32
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,533
Hi
I have a problem with my Calibre Interactive when I try to run DRC for my layout verification using Virtuoso 6.1.3. It's show the error ' The following products could not be licensed sufficiently". Is it related to the Calibre license because the technician who install my Calibre said the license is find.
Hope somebody can help me please..
 

Hi,

If you use the version 2010 of Calibre, you need to upgrade to the last Mentor licensing software FLEXnet (v11.6.1).
 
It was a too older mgcld deamon version .
 
Hi staric,

I have the same problem!!! And I guess that my problem is the old version of the mgcld deamon.
Do you know the mgcld deamon version that is adequate for Calibre_2010?
I have not found this information in the manual.

Thank you very much,
 

Hi,

You can use the mgcld that is contained in <calibre_install_path>/pkgs/mgls/lib. Its version will correspond to Calibre version you are using.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top