Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem With KS0108 GLCD when using interrupts

Status
Not open for further replies.
M

mohsen asloni

Junior Member level 1
Joined
Oct 30, 2004
Messages
16
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,283
Location
Iran
Activity points
87
Dear friends,

I wrote a program for GLCD ks0108 and it works very fine(interrupts are disabled) but when I enable timer interrupt(~50Hz) , it doesn't work. then before using GLCD, i disabled interrupts and enabled it after that, but it doesn't work. I'm confused.

Thanks for your kindness
 

Hi

Check your interrupt routine whether it change register data (re set some register)

All the bast

Bobi

The microcontroller specialist
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top