123jack
Advanced Member level 2
I need a plastic enclosure for a hand held meter circuit board/battery.
Something more similar to a TV remote rather than a DVM.
Can anyone suggest the best way to get this done (I've never done anything like this)
I have access to 3DS Max to visualise or presumably create DXF or whatever
but I dont know anything about the materials/ pricing/ manufacturing etc of this
type of thing. (I am UK based if thats helpful in any way)
Is there any low cost software to help maybe?
Any advice on any aspect of this welcome.
Thanks
jack.
Something more similar to a TV remote rather than a DVM.
Can anyone suggest the best way to get this done (I've never done anything like this)
I have access to 3DS Max to visualise or presumably create DXF or whatever
but I dont know anything about the materials/ pricing/ manufacturing etc of this
type of thing. (I am UK based if thats helpful in any way)
Is there any low cost software to help maybe?
Any advice on any aspect of this welcome.
Thanks
jack.