Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

stepper motor rating, how to drive it?

Status
Not open for further replies.
J

jit_singh_tara

Full Member level 6
Joined
Dec 22, 2006
Messages
325
Helped
9
Reputation
18
Reaction score
4
Trophy points
1,298
Location
Delhi , India
Activity points
4,293
stepper motor rating?

i have a bipolar stepper motor rating 4.7Amp/ phase .1.8 deg . 1.95Nm .
I have seen this motor running at 50V.


Please suggest me how to proceed with driver card.

1.how much current will motor take on full torque .
2.Which rating power supply should be used.
2.what circuit should i use after l297 ic .
 

stepper motor rating?

hi i build small circuit without l297 and i use mosfet transistor to run stepper coil i understand it good and it can be run 4 phase stepper motor and we can run from 5v to 50 volt and we can match power of mosfet transistor with power of stepper motor
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top