Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

interfacing LM35 to PIC16F877

Status
Not open for further replies.
R

rsa60

Newbie level 1
Joined
Apr 12, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Lebanon
Activity points
1,294
Hi all,

I am working on a priject where am interfacing a temperature sensor (LM35), an irradiance temperature, a current sensor, and a voltage input measurment, all together to PIC 16F877.

I am starting now with LM35,
any one has done any similar project ?

I appreciate your help.

Thanks a lot.

Rola
 

I have used LM35 with PIC16f877A.Its easy to interface.I have used CCS for programming.Which compiler you are using.
If you want to measure AC voltage, then i can give you an idea how to measure it using microcontroller.
 
  • Like
Reactions: jujan

    J

    jujan

    Points: 2
    Helpful Answer Positive Rating
you can use 10 bit in built ADC and you can calibrate your temp range in which you want to measure the temp

and another thing is if you are inter facing more then one sensor give me detail about sensors so i can help you more

and also give more detail about your project


EnJoy
:)
 

CAN ANY TELL ME A GOOD WAY TO STUDY MICROCONTROLLERS ON OUR OWN

Dont use all caps. Look at this topic

MODERATOR ACTION:
MODERATOR ACTION: MODERATOR ACTION: MODERATOR ACTION:
 

can u post the schematic and the source code ??
 

To FARAH F MIRZA:
You can study microcontroller using any book.
Book by mazidi is good at initial level
Click to expand...

To dahroug:
Here you can find the basic code for interfacing lm35 with microcontroller.

Interfacing lm35 with microcontroller hardware side is easy one.
Lm35 is a 3 pin device,1 pin should be connected to Vcc, 1 pin should be connected to Gnd and 1 pin should be connected to microcontroller's analog pin.
Click to expand...
 

thnk u so so much
but plz post the schematic if u can

i want to discuss some things with u
plz post ur mail if u don't mind

thannk u so much anyway

Added after 5 minutes:

iam using mikroc
 

I have no schemetic right now.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top