Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

enabling telnet from cmd

Status
Not open for further replies.

showntimoon

Junior Member level 3
Joined
Aug 27, 2006
Messages
28
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
1,478
can i enable the telnet from cmd ???
i didn't find any commands to do so ...
i found the command " services createsvrany ....etc " to create a new service
but it doesn't work :!:
have u any ideas ??
 

Which operating system are you using.
If you are using Windows Vista or Windows 7.
Then By Default the telent command is not available. You can enable telnet command from "Turn On/Off windows features" from "Add remove program"
 

doesnt just typing 'telnet' takes u to ms telnet?
mine does.. 8O
 

it does
but u can't connect to the target computer unless the telnet service is enabled in it.
 

well i found the command ..
sc config tlntsvr start= auto
then to start the service:
net start telnet
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top