Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

cosimulation with ADS for oscillator design?

Status
Not open for further replies.
alperuslu

alperuslu

Full Member level 2
Joined
May 16, 2009
Messages
130
Helped
32
Reputation
64
Reaction score
25
Trophy points
1,308
Location
Istanbul , Turkey
Activity points
1,975
Oscillator Cosimulation

Is there any way to make cosimulation with ADS for oscillator design?


Thanks
 

Oscillator Cosimulation

Cosimulation with layout ??
If it's so, yes.You may simulate layout with your active part of your oscillator in a single schematic by using HB.
 

Re: Oscillator Cosimulation

where should i put oscport component? In layout window i put between negative resistance and load network but when i cosimulate program gives error it says there is no oscport component?
 

Oscillator Cosimulation

Oscport component should be placed in "schematic" window, not in layout one.Your layout must be transferred onto schematic window and then all layout ports should be terminated with proper components e.g. load, resonator,Vcc,GND etc. and then oscport component can be placed opened loop line.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top