Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: How to observe 50-ohm transmission line in @DS software
You should look for S11 (return loss) being <-20 dB or less and S21 as high as possible. Generally >-0.5 dB, but of course very much depending on conductor length, dielectric used, etc.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.