Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SD card spi protocol help!

Status
Not open for further replies.
Y

YangZ

Newbie level 5
Joined
Dec 4, 2009
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Malaysia
Activity points
1,352
Hey everyone!

I would like to know for the sd card spi protocol, can i sample my data and shift my data both at the rising edge of SCK? I have research about spi protocol and i know that for SD card we can either use CPHA =1, CPOL=1 or CPOL=0 and CPHA =0. But i just wanted to know if its really possible to sample data and shift data at the rising edge of the SCK.

I thank you all for you time and advice on my problem.

Regards,
YangZ
 

yup you just read sd card simplified protocol spi mode it will tell you mostly all...
 

THanks guys for your help! Clarify all my doubts =]
 

By SD specification, you have to keep at least the required setup and hold times related to rising edge. Obviously, the specification
is based on a standard SPI mode 0/3 timing: Shift out on falling edge.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top