Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

US or Canada designer needed to do PIC w/ Ethernet board

Status
Not open for further replies.

0x9Design

Newbie level 1
Joined
Jan 14, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
New York, NY
Activity points
1,292
I need a schematic and surface-mount PCB designed that will use a PIC18F66J60. The finished design will probably be less than ninety pins/contacts. It's a pretty simple device, but quality matters. It will be used in automotive conditions. The design should be heavily biased toward a low component count, even at the expense of increasing the component cost by a few dollars.

A designer in the US or Canada is preferred for legal reasons, and it will be done as a "work made for hire".

If you have experience with designs using Ethernet and enjoy doing quality work, then please contact me. Enclose a sample of your work or a copy of your resume w/references.

Cheers,
Peter
 

Hi,

We are an embedded systems company doing design and development.We have experience in dealing Microcontrollers such as AVR,PIC and ARM.We have also developed Ethernet stand alone module.We are quite sure with our experience we will be to give you quality work.We are a company based in India.

Please contact us in the below address.If you want our profile and our product list please send your mail id.

LUMINLABZ
#13,11th Main,
Jayanagar 5th Block
Bangalore-560041
Ph no: 080-22451619

www.luminlabz.com
e-Mail:info@luminlabz.com
 

Check out our web site: www.SoftwareConceptsInc.com. We are a US-based company specializing in Machine-to-Machine communications, and Remote Monitoring & Control Systems. We are a Microchip Authorized Design Partner with more than 30 years experience in enbedded system design and development.
 

Hi,

Please give us your exact requirement so that we can design the schematic for you.

Regards

LUMINLABZ
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top