Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ICSP connections-how to make propr use of the icsp signals?

Status
Not open for further replies.
sidy50

sidy50

Member level 4
Joined
Dec 31, 2009
Messages
79
Helped
14
Reputation
28
Reaction score
3
Trophy points
1,288
Location
India
Activity points
1,839
ICSP connections

hi all,

i have a JDM 2 based programmer wich provides 5 Icsp signals for programming..
vpp - MClr - 15v, vdd, gnd, pgd, pgc...
i succesfully program sm pic like 16f628a,f84a etc
but i dunno how to make use of the icsp in circuit...
coz wen i tried programming smtimes the software would detect the ic smtimes not...also wen i read the pic the data read was improper...
pls suggest how to make propr use of the icsp signals...
i want to construct basic pic circuit on breadboard and start Nigels tutorial...
thanx
MOD:Use Full grammer for posting. Using Short hand/ SMS languages will have a WARNING delivered to you next time
 

Re: ICSP connections

Hi,

See my comments on this post a few hours ago -


If you want to move on to bigger chips then I would strongly suggest you look at building a Pickit2 Lite as featured many times in this forum .
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top