Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

JFET source Follower - not simmetrical bias

Status
Not open for further replies.

elaine_garcia07

Newbie level 1
Joined
Jan 7, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Philippines
Activity points
1,287
JFET source Follower

what causes the clipping of a portion of the negative cycle of the output voltage signal? [/quote]
 

JFET source Follower

it may be because your j fet is not symetrically biased. and thus your transistor is going to cut of
try to:
1- biasing your transistor symetrically
2- apply smaller voltage at the input
 

Re: JFET source Follower

Your Q point is not in the centre. If you want proper amplifcation properly bias the JFET
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top