+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Junior Member level 3
    Points: 1,701, Level: 9
    Achievements:
    7 years registered

    Join Date
    May 2009
    Location
    PAk
    Posts
    30
    Helped
    0 / 0
    Points
    1,701
    Level
    9

    Interface of SPI sensor with MIcrocontrolller

    HI

    i am looking for the intergration of SPI viscosity sensor with PIC controller PIC18f452 ,i have design a circuit but not able to program it ,due to less knowlegde of SPI protocol ,the sensor is actully made by seguncty i also have some data for it Could any one can be able to create the code for it ,i also have some code but it is for PIC18f8680 controller but it is on very large controller
    so plz help me i can also send some links as well as some information regrad about sensor
    here is link for the sensor
    http://www.sengenuity.com/tech_re/Vi...spec_sheet.pdf

    the device used to connectd the sensor so that it is able to send correct viscosity by just sending V to it
    http://www.sengenuity.com/tech_ref/visconnect.pdf

    i have attched the information for SPI sensor which have two adc of 22bit
    thanks

    •   AltAdvertisment

        
       

  2. #2
    Full Member level 5
    Points: 2,729, Level: 12

    Join Date
    Jun 2008
    Location
    Egypt/Canada
    Posts
    246
    Helped
    20 / 20
    Points
    2,729
    Level
    12

    Interface of SPI sensor with MIcrocontrolller

    read in the compiler help the API's used for SPI interface, in C18 and MikroC compilers there are API's for such interface, take care you are connecting the right pins of the SPI between microcontroller and sensor.



    •   AltAdvertisment

        
       

  3. #3
    Junior Member level 3
    Points: 1,701, Level: 9
    Achievements:
    7 years registered

    Join Date
    May 2009
    Location
    PAk
    Posts
    30
    Helped
    0 / 0
    Points
    1,701
    Level
    9

    Interface of SPI sensor with MIcrocontrolller

    thanks
    i will check actullly i dont have so much about the SPI i have create the code but it very simple.and does not work properly ,actully the pin configruation for the device to connect is right one ,i only required code for the this circuit
    once agiain thanks



--[[ ]]--