Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PLease help with AD7730 device

Status
Not open for further replies.

saddam_lobaed

Newbie level 2
Joined
Mar 3, 2007
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,296
PLease help with AD7730

Dear Friends.
please i need your help with this IC as i'm trying to use it in a weigh scale CCT but with no luck.
I'm using 16F877A programmed with MikroBasic, I did test all the output instruction to the Ad7730 from the PIC using Protues to see is i made any mistake in the bit stream but i found the protues give me exact result i took all the code for initiation and calibration from the datasheet of the IC. but what ever i do i have no response from the IC at least to have the RDY signal chenged when the calibration process finshed.

i looked through the post and i have this note (you have to reset ad7730 before each instruction; its is a bug for ad7730). is that real.

pleaaaaaaaaaaaaaas i need you advice and any help will be greatly appreciated

best regards
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top