Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Load pull simulation in ADS need help

Status
Not open for further replies.

TerryADS

Full Member level 2
Joined
Oct 31, 2008
Messages
133
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Location
USA
Activity points
2,066
Hi friends,
The first time simulate load pull,a question about the DC block and DC feed components as attached photo,whether i need modify the cap. and RF choke values if i use another device and different frequencics simulated.Or i insert the device into the example directly(why?)?
Thanks,
 

No..
The values are sufficiently high for RF frequencies ( if they are higher than 100MHz )
 

    TerryADS

    Points: 2
    Helpful Answer Positive Rating
Don't modify these values, it's acting as a bias tee. You can measure different devices in different frequency band with the same bias tee.
The simulation result is not depending on these values.
 

    TerryADS

    Points: 2
    Helpful Answer Positive Rating
These caps and inductors are large enough. They hardly have any effect on smith chart for high frequency application.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top