+ Post New Thread
Results 1 to 4 of 4
  1. #1
    Full Member level 2
    Points: 1,679, Level: 9

    Join Date
    Oct 2008
    Location
    USA
    Posts
    133
    Helped
    2 / 2
    Points
    1,679
    Level
    9

    Load pull simulation in ADS need help

    Hi friends,
    The first time simulate load pull,a question about the DC block and DC feed components as attached photo,whether i need modify the cap. and RF choke values if i use another device and different frequencics simulated.Or i insert the device into the example directly(why?)?
    Thanks,

    •   AltAdvertisement

        
       

  2. #2
    Advanced Member level 5
    Points: 30,406, Level: 42
    BigBoss's Avatar
    Join Date
    Nov 2001
    Location
    Turkey
    Posts
    4,458
    Helped
    1339 / 1339
    Points
    30,406
    Level
    42

    Load pull simulation in ADS need help

    No..
    The values are sufficiently high for RF frequencies ( if they are higher than 100MHz )


    1 members found this post helpful.

    •   AltAdvertisement

        
       

  3. #3
    Full Member level 6
    Points: 3,619, Level: 14
    Achievements:
    7 years registered

    Join Date
    May 2007
    Posts
    352
    Helped
    30 / 30
    Points
    3,619
    Level
    14

    Re: Load pull simulation in ADS need help

    Don't modify these values, it's acting as a bias tee. You can measure different devices in different frequency band with the same bias tee.
    The simulation result is not depending on these values.


    1 members found this post helpful.

    •   AltAdvertisement

        
       

  4. #4
    Member level 4
    Points: 2,261, Level: 11
    penghan's Avatar
    Join Date
    Sep 2004
    Location
    Shanghai
    Posts
    74
    Helped
    4 / 4
    Points
    2,261
    Level
    11

    Re: Load pull simulation in ADS need help

    These caps and inductors are large enough. They hardly have any effect on smith chart for high frequency application.



--[[ ]]--