Leonard K
Newbie level 6
crossprobing
When I select something in an OrCAD Capture schematic it always zooms right in on the part in Allegro PCB layout when I have "intertool communication" turned on.
I like the intertool communication (cross probing) but I want it to stop zooming in on the selected part in the layout. I would like it to just highlight the part. Is there any way to shut off the zooming?
If I select something in the layout, it only highlights it in the schematic, it doesn't zoom in on it, which is OK.
When I select something in an OrCAD Capture schematic it always zooms right in on the part in Allegro PCB layout when I have "intertool communication" turned on.
I like the intertool communication (cross probing) but I want it to stop zooming in on the selected part in the layout. I would like it to just highlight the part. Is there any way to shut off the zooming?
If I select something in the layout, it only highlights it in the schematic, it doesn't zoom in on it, which is OK.