Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Debugging tone decoder(567) for FSK demod..help needed

Status
Not open for further replies.

akshay_d_2006

Member level 4
Joined
Jul 31, 2009
Messages
76
Helped
12
Reputation
24
Reaction score
4
Trophy points
1,298
Location
Mumbai
Activity points
1,919
567 tone decoder

I have been using LMC567 foe FSK demodulation.
Is it feasible enough.
An FSK modulated wave is applied to pin 3 as i/p. R and C are selected to the freq. value which is the same value of the freq. of the modulated signal when the digital precedor(counterpart) of it had a low.
thus I will get a low when the freq is detected and when not (where the digitally high equivalent of freq is as the i/p) i'll get a high as the LMC o/p.
Thus the original signal is traced or demodulated.

To start with, simply decting the freq and gettin respective o/p, I did connections the following way.
pin 1 and 2 connected to ground via a 1nF capacitor.
pin 3 as input.
pin 4 as +Vcc
pin 5 had a 10K resister then connected to pin 6
pin 6 had the other end of 10K resistor and a capacitor of 0.1uF going to grnd.
pin 7 Grnd.
pin 8 O/p, A pull up resistor of 10K, Across measurment going to CRO

Now thr RC combination gives me Center freq-Fo=903 Hz

And 1kHz comes in its detectable pass band.

When to its i/p I give other than 1KHz I get High output (5V)
But when i give to its i/p 1kHz, I get a high freq Square wave in o/p.(On CRO)

What should be the i/p as in- square wave/sine/triangular wave???
When the i/p lies in its passband freq of adjusted center freq. What should I expect as a output. Should it be low level voltage, or when i'm gettin a high freq square signal is proper.

PLZ PLZ Guide and help.. In V much need.... Want to submit the project quickly.

Take care
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top