Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PAC and AC analysis - request for manual

Status
Not open for further replies.

tyanata

Full Member level 2
Joined
Nov 27, 2003
Messages
123
Helped
6
Reputation
12
Reaction score
3
Trophy points
1,298
Location
Sofia
Activity points
975
pac analysis

Hi,

I am new in cadance, till now I have used only PSpice so sorry for may be stupid question. I make SD ADC so I am designing OP amp for the untegrator. I made AC analysis with continuos CMFB of the amp. In reality amp will operate with SC CMFB. From manuals of Spectre as I understood there is some PAC analysis which makes some thing like ordinary AC analysis but using real SC operating points. Is it real or is it wrong. So if it is real, are plots from this analysis look like those from ordinary AC analysis (gain versus frequency, andphase versus frequency).

Can any one post useful manual, how to run this analysis!
 

what is pac analysis??

It might not be updated version. but it's helpful to answer your questions I guess.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top