Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to design a DIY 915MHz monopole antenna?

Status
Not open for further replies.

blueblin

Banned
Joined
Jul 18, 2008
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
0
Can anyone help me up for this? How to design a DIY 915MHz monopole antenna? Urgent..


Thanks for your help very much..
 

monopole antenna

hi there

well its not very difficult . you need a metallic sheet to act as a ground plane and metallic wire to make monopole antenna.

the monopole is an antenna which resonates when its length is quarter of wavelength at the operating frequency which is 915MHz in your case

so you need to cut the wire equal to 81mm. and then feed it with the coax cable through the ground plane

regards
 

diy monopole antenna

shahid78, thanks for the help. I will try to design the antenna. thanks a lot..
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top