Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ADS comparsion to 3-Dsimulator

Status
Not open for further replies.
T

taglub

Newbie level 4
Joined
Dec 18, 2008
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,322
when you draw a conductor in the 3D simulator then through the adjusting of the boundary conditions you can determine whether this conductor behaves like a T.L(here S12=0dB in case of two ports contected to the terminal of the conductors)or like an radiator atntenna(if you put the boundaries open then it will behave like a radiator).
but in the ads when you draw a conductors the it will behave allways like a T.L.
i dont trust the ADS results in designing an Antenna.
Am i right???


thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top