Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to plot Vt (threshold voltage) Vs. sweep parameter

Status
Not open for further replies.

dhasmana

Member level 5
Joined
Jan 19, 2005
Messages
87
Helped
8
Reputation
16
Reaction score
0
Trophy points
1,286
Location
Bangalore , India.
Activity points
578
Hello ,

How can I plot Vt (threshold voltage) Vs. sweep parameter in spectre simulations?

Regards,
Jitendra.
 

do dc analysis, then Tools->Results Browser, open dc-dc and find M0/vth (assuming your transistor instance is M0)
 

Hello,

Thanks for the reply.Inside the dc-dc , I can see MN0 transistors has 5 listed parameters: MN0.di , gi , r1 , r2 , r3 and si. Vt is not listed there.What should I do?
Regards,
Jitendra.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top