Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to reset S7-200 PLC

Status
Not open for further replies.
S

styrk

Newbie level 1
Joined
May 13, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
reset s7 200

Hi.

Iam getting this error "Hardware detected a framing error" and now iam unable to communicate with my S7-200 PLC (CPU 224). I have tested my computer/cable with another PLC and it works just fine.

Is there any way to reset the PLC completely without using software? I was looking alot in the S7-200 manual but did not find a way.

- Rasmus
 

reset s7-200

Iam getting this error "Hardware detected a framing error" and now iam unable to communicate with my S7-200 PLC (CPU 224). I have tested my computer/cable with another PLC and it works just fine.
Click to expand...

If you use STEP7-mico/win, in COMMUNICATIONS - try the "search all baud rates" option ..
Maybe the PLC is setup with different baud rate ..

Rgds,
IanP
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top