deperkin
Member level 2
uln2803a circuit
I have attempted to use both a L6201 and an L6203 to drive a 24V DC motor for a project i am running out of time on...
Both have successfully let out all of the blue smoke trapped inside...
The L6201 is rated at 1.5A continuous current and the L6203 is rated at 4A...
I have checked the wiring and cannot seem to figure out why this motor (of which i cannot seem to find any good specs on) has burned both of these full bridges.
I have measured the current and only seem to see about 0.7A continuously while driving the motor.
Would a ULN2803A darlington help with this problem ???
any suggestions on how i can wire this up with a full bridge ???
THank you for all your help!
BR
deperkin
I have attempted to use both a L6201 and an L6203 to drive a 24V DC motor for a project i am running out of time on...
Both have successfully let out all of the blue smoke trapped inside...
The L6201 is rated at 1.5A continuous current and the L6203 is rated at 4A...
I have checked the wiring and cannot seem to figure out why this motor (of which i cannot seem to find any good specs on) has burned both of these full bridges.
I have measured the current and only seem to see about 0.7A continuously while driving the motor.
Would a ULN2803A darlington help with this problem ???
any suggestions on how i can wire this up with a full bridge ???
THank you for all your help!
BR
deperkin