Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Metallic losses, COMSOL - howto observe metallic losses

Status
Not open for further replies.
E

elifelite

Junior Member level 3
Joined
Apr 12, 2006
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,433
Metallic losses, COMSOL

Hi all,

I've been trying to simulate electric field inside a waveguide with
metal rods. But it seems there is less losses than as it should be. I
defined rods as a subdomain with epsilon and sigma but it gives wrong
results, then I tried impedance boundary condition for rods but I
don't know what value to be given the surface electric field, or what
else I can do to observe metallic losses?

Thanks.
 

Metallic losses, COMSOL

Setting some proper value for \sigma is the right way. Maybe the provided value was not correct. BTW, how did you check the result?
 

Re: Metallic losses, COMSOL

I think, I've set a proper value for sigma, I checked transmission results from a paper. Anyway, the problem is to define metallic rods is that enough defining as a subdomain and giving parameters? Or should I take skindepth into account, but how? For this I tried to use boundary condition for rods, but still have the same problem.

Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top