+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Newbie level 1
    Points: 893, Level: 6

    Join Date
    Dec 2007
    Posts
    1
    Helped
    0 / 0
    Points
    893
    Level
    6

    ares layout

    Hi folks,
    I am running into a small problem here.
    I have created a PCB layout directly in ARES without using a schematic or ISIS. Now i want to generate powerplane in ARES. But somehow i am unable to change the class of my Vcc and Gnd nets from SIGNAL to POWER.

    Can anyone tell me how to do this? Please Help.

    Thanks
    Ashish

    •   AltAdvertisment

        
       

  2. #2
    Full Member level 1
    Points: 3,115, Level: 13

    Join Date
    Jan 2004
    Posts
    113
    Helped
    17 / 17
    Points
    3,115
    Level
    13

    Re: PROTEUS ARES Layout || Edit NET class? || Urgent

    You can't.

    Net classes are denoted in ISIS via a wire label (CLASS=xxxxx) on the net in question and then edited/configured in ARES.

    If you haven't got a schematic then you haven't got a proper netlist and all nets are SIGNAL class.

    Iain.


    1 members found this post helpful.

--[[ ]]--