Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Isolated offline smps -how to drive the UC2825 from the opto

Status
Not open for further replies.

eem2am

Banned
Joined
Jun 22, 2008
Messages
1,179
Helped
37
Reputation
74
Reaction score
24
Trophy points
1,318
Activity points
0
isolated offline smps

hello,

i am doing an isolated offline smps with UC2825 PWM controller.

UC2825 Datasheet
http://focus.ti.com/lit/ds/symlink/uc3825.pdf

I am just wondering how to drive the UC2825 from the opto (4N35)

4N35 Datasheet
http://www.datasheetcatalog.org/datasheet/fairchild/4N35.pdf

I am wondering if i can connect 5V to the error amplifier output (pin 3 ) and then connect the collector of the opto transistor to pin3 and the opto-transistor's emitter to ground?

Any thoughts gratefully appreciated.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top